|
Finishing Touches 10/12 |
|
||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
|
|||||||||||
 |
|
|
|
|
|
|
||||
 |
The subwoofer amplifiers are being mounted in their own enclosure | |||
 |
Here is the back of one of the amplifiers. They have been modified for 1db of boost at 20-25hz | |||
 |
The
base for the projector mount is attached to the ceiling.
4"
sheetrock screws are driven into 2 ceiling joists and 2x10
reinforcment
put in
before sheetrock. Each screw only supports about 5lbs. Strength in
numbers.
|
|||
 |
The
mount needed to be dropped 7" for proper screen height. 2x10s
were stacked
screwed
and glued to get the height.
|
|||
 |
The
screen frame has been assembled and mounted on the wall.
|
|||
 |
Projector
is hung. The projector mount is lag bolted to the 2x10s above.
Wiring
and IR flasher is connected. The orange box runs the exhaust fans
which
will pull air from the hush box via the duct
|
|||
 |
The
finished setup before carpet. The screen snaps into place and is very
tight.
|
|||
 |
The lutron lighting control was flush mounted in the rear speaker column. IR is run to it for remote operation. | |||
 |
The
equipment rack is missing some custom rack shelves at this point.
|
|||
 |
What a mess! | |||
|
All trademarks used are properties of their
respective owners |
||||